Owner`s manual

AWD AUTO TO LOW RANGE

NOTE: When shifting into or out of LOW RANGE some

gear noise may be heard. This noise is normal and is not

detrimental to the vehicle or occupants.

Shifting can be performed with the vehicle rolling 2 to

3 mph (3 to 5 km/h) or completely stopped. Use either of

the following procedures:

Preferred Procedure

1. With the engine running, slow the vehicle to 2 to

3 mph (3 to 5 km/h).

2. Shift the transmission into NEUTRAL.

3. While still rolling, rotate the AWD control switch to

the desired position.

4. After the desired position indicator light is ON (not

flashing), shift the transmission back into gear.

Alternate Procedure

1. Bring the vehicle to complete stop.

2. With the ignition switch in ON/ RUN position and

engine running, shift the transmission to Neutral.

3. Rotate the AWD control switch to the desired position.

4. After the desired position indicator light is ON (not

flashing), shift the transmission back into gear.

NOTE: If Steps 1 or 2 of either the Preferred or Alternate

Procedure are not satisfied prior to attempting the shift or

if they no longer are being met while the shift attempt is

in process, the desired position indicator light will flash

continuously while the original position indicator light is

ON, until all requirements have been met.

STARTING AND OPERATING 401