Owner`s manual

CAUTION!

Do not touch the new bulb with your fingers. Oil

contamination will severely shorten bulb life. If the

bulb comes in contact with any oily surface, clean the

bulb with rubbing alcohol.

Front Fog Lamps

1. Reach through the cutout in the splash shield and

rotate the bulb’s electrical connector one-quarter turn

counterclockwise and remove it from the fog lamp

housing.

2. Remove the bulb from the connector and install the

replacement bulb.

3. Install the bulb and connector assembly into the fog

lamp housing and rotate the connector one-quarter

turn clockwise to lock it in place.

CAUTION!

•

Do not touch the new bulb with your fingers. Oil

contamination will severely shorten bulb life. If

the bulb comes in contact with any oily surface,

clean the bulb with rubbing alcohol.

• Always use the correct bulb size and type for

replacement. An incorrect bulb size or type may

overheat and cause damage to the lamp, the socket

or the lamp wiring.

Rear Tail, Stop and Turn Signal Lamps

The rear tail, stop, and turn signal lamps are LED. See

your authorized dealer for replacement.

Rear Liftgate Mounted Back-up Lamps

1. Raise the liftgate.

2. Use a fiber stick or flat blade screw driver to pry the

lower trim from the liftgate.

MAINTAINING YOUR VEHICLE 581