User Guide Instruction Manual

Before You Begin Programming HomeLink®
•Ensurethatyourvehicleisparkedoutsideofthegaragebeforeyoubeginprogramming.
•Forefficientprogrammingandaccuratetransmissionoftheradio-frequencysignalitis
recommended that a new battery be placed in the hand-held transmitter of the device
that is being programmed to the HomeLink
®
system.
•Eraseallchannelsbeforeyoubeginprogramming.Toerasethechannels,placethe
ignition switch into the ON/RUN position, then press and hold the two outside
HomeLink
®
buttons (I and III) for up to 20 seconds. The Driver Information Display
(DID) will display “CLEARING CHANNELS”. Release the buttons when the DID
displays “CHANNELS CLEARED”.
NOTE:
•ErasingallchannelsshouldonlybeperformedwhenprogrammingHomeLink
®
for the
first time. Do not erase channels when programming additional buttons.
•Ifyouhaveanyproblems,orrequireassistance,pleasecalltoll-free1-800-355-3515
or, on the Internet at HomeLink.com for information or assistance.
Programming A Rolling Code
•ForprogrammingGarageDoorOpenersthatweremanufacturedafter1995.These
Garage Door Openers can be identified by the “LEARN” or “TRAIN” button located
where the hanging antenna is attached to the Garage Door Opener . It is NOT the button
that is normally used to open and close the door . The name and color of the button may
vary by manufacturer .
1. Place the ignition switch into the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the HomeLink
®
button you wish to program while keeping the HomeLink
®
indicator light in view.
3. Simultaneously push and hold both the Homelink
®
button you want to program and
the hand-held transmitter button.
4. Continue to hold buttons until the DID display changes from “CHANNEL # TRAIN-
ING” to “CHANNEL # TRAINED”, then release both buttons.
NOTE:
If the DID displays “DID NOT TRAIN” repeat from Step 2.
5. At the garage door opener motor (in the garage), locate the “LEARN” or “TRAINING”
button. This can usually be found where the hanging antenna wire is attached to the
garage door opener motor . Firmly push and release the “LEARN” or “TRAINING”
button.
NOTE:
You have 30 seconds in which to initiate the next step after the LEARN button has been
pushed.
ELECTRONICS
142