User Guide Instruction Manual

Engine Starting/Stopping - Automatic Transmission

Starting

•

Place the shift lever in PARK or NEUTRAL.

•Whilepushingthebrakepedal,pushthe

ENGINE START/STOP button once. If

the engine fails to start, the starter will

disengage automatically after 10 sec-

onds.

•Tostopthecrankingoftheengineprior

to the engine starting, push the button

again.

Stopping

•PlacetheshiftleverinPARK.

•PushtheENGINESTART/STOPbutton

once. The ignition switch will return to

the OFF position.

•

If the shift lever is not in PARK, the ENGINE START/STOP button must be held for two

seconds and vehicle speed must be above 5 mph (8 km/h) before the engine will shut off.

NOTE:

If the ignition switch is left in the ACC or RUN (engine not running) position and the

transmission is in P ARK, the system will automatically time out after 30 minutes of

inactivity and the ignition will switch to the OFF position.

Engine Starting/Stopping — Manual Transmission

Starting

•PushandholdtheclutchpedalwhilepushingandholdingtheENGINESTART/STOP

button. Release the button when the engine starts. If the engine fails to start within 15

seconds, release the button, wait 10 to 15 seconds, then repeat.

•Tostopthecrankingoftheenginepriortotheenginestarting,releasethebutton.

Stopping

•Withthevehiclestopped,placetheshiftleverinNEUTRAL.

•PushtheENGINESTART/STOPbuttononce.TheignitionswitchwillreturntotheOFF

position.

• If the vehicle speed is above 5 mph (8 km/h), the ENGINE START/STOP button must be

held for two seconds before the engine will shut off. The ignition switch position will

remain in the ACC position until the vehicle is stopped and the button is pressed twice

to the OFF position.

NOTE:

If the ignition switch is left in the ACC position, the system will automatically time out

after 60 minutes of inactivity and the ignition will switch to the OFF position.

1 – Start/Stop Button

GETTING STARTED