User Guide Manual

Power Lumbar

•Pushtheswitchforwardtoincreasethe

lumbar support. Push the switch rear-

ward to decrease the lumbar support.

•Pushingupwardordownwardonthe

switch will raise and lower the position of

the support.

Memory Seat

The memory seat feature allows you to set

two different driver seating positions (ex-

cluding lumbar position), outside mirrors,

radio station preset settings and tilt/

telescoping steering column position (if

equipped). The memory seat buttons are

located on the driver's door panel.

To s e t a memory position:

1. Cycle the vehicles ignition to the ON

position.

2. Adjust all memory profile settings.

3. Press and release the S (SET) button.

4. Press and release the 1 or 2 button

within five seconds.

NOTE:

Before programming your RKE transmitters

you must select the feature through the

Uconnect

system. Refer to “Uconnect

Settings ” in “Understanding Y our Instru-

ment Panel” in the Owner's Manual on the

DVD for further details.

To p r o g ram a Key Fob to t h e memory position:

1. Cycle the vehicles ignition to the OFF position.

2. Select the desired memory profile 1 or 2.

3. Press and release the S (SET) button on the memory switch, then within five seconds

press and release the 1 or 2 button accordingly .

4. Press and release the LOCK button on the RKE transmitter within 10 seconds.

•Torecallthesavedpositions,press1or2onthememoryswitchorpressUNLOCKon

the programmed RKE transmitter .

Power Lumbar Switch

Driver’s Memory Buttons

GETTING STARTED