User Manual

3. A-100 signal flow System A - 100
doepfer
10
If on the other hand you’d like to have the same
internal CV and gate available on two busses at
once, you need to link the two together, with the
special CV/gate leads, the A-100 BC.
This is how you go about it:
D Remove the A-100 from the electrical supply.
D Remove Jumpers J1 and J2(see p.9) from the
upper (see Fig. 8 !) and lower (see Fig. 8 ")
system bus boards.
D Replace the jumpers with the special CV / gate
leads, A-100 BC (see Fig. 8 1, 2).
A
Make absolutely sure that you connect the
leads correctly, joining up the upper INT CV
with the lower INT CV, and the upper INT
GATE with the lower, to avoid possible
damage when you switch back on!
Fig. 8: Making a common INT.CV and INT.GATE
signal path between the upper and lower
busses.
➀
➁

