Manual

• available menus/buttons with LEDs
o Mode: selects the key for CV1 when more than one key is operated ar the
same time
 lowest key priority
 highest key priority

last key priority
o Transpose, 2 different transpose modes can be selected in the configuration
menu
 0/+1 octave or
 0...+12 semitones
o
Retrigger: this parameter controls the Gate behaviour while legato play (i.e.
when a key is operated while another one is already pressed), 0 means that the
Gate is not reset in this case, 1...20 defines different reset times in
milliseconds. This is necessary from our experience as some ADSR generators
require a longer reset time to be retriggered. For the A-100 envelope
generators (e.g. A-140) setting "1" is OK, i.e. shortest reset time is sufficient.
For other envelope generators the minimum reset time has to be tried out.
o Hold: If this key is operated the Gate is held even if the key is released
o
Up/Down: buttons to increase/decrease the value of the currently selected
menu. In addition the value of the selected parameter can be increased by
operating the corresponding menu button again.
• additional basic parameters are adjusted in a special configuration mode and
include parameters that are normally fixed, i.e. they are not changed during the
play. The configuration mode is selected if the up or down button is held down
during power on:
o
keybed type (2/3/4/5 octaves, necessary for transpose and offset options, has
to be set to "4" for the ready built version)
o transpose mode (0/+1 octave or 0...+12 semitones)
o Gate polarity (useful if an inverted Gate behaviour is required, e.g. for Moog
synthesizers or systems)
•
An external power supply (7-12VDC@min. 250mA) is used. Within Europa the
wall outlet power supply adapter for 230V mains voltage and European type
mains plug is included with the A-100CGK. In other countries the power supply
has to be purchased by the user in his country. If there is a Doepfer
representative in your country (see dealer link on our website) please ask the
representative if the power supply is included in your country.
•
four 80 cm A-100 patch cables are included to connect the four outputs of the A-
100CGK to the A-100 system. If your system uses 1/4" jack sockets special
cables (3.5 mm to 1/4" jack plug) have to be ordered separately. These cables
can be found in the accessories section of the price list on our website.
•
As soon as the A-100CGK adapter module is available the keyboard can be
powered from the A-100 system. In this case no external power supply adapter is
necessary. The adapter module is in the planning stage.
•
Dimensions: ~ 790 length x 200 depth x 65 height, measures in mm (ready built
version with octaves keybed and metal case)
•
weight: ~ 4.5 kg (ready built version with octaves keybed and metal case)