Manual

9. Appendix System A - 100

doepfer

Fig. 1: Connecting the ribbon cable to the module

D Now join the free end of the ribbon cable (see

Fig. 2) to the nearest available position on the

system bus board (see

in Fig. 2).

Again ensure that the coloured marking on

the ribbon cable is at the bottom of the

module’s connector (see

in Fig. 1) and

that the connection is perfect, and pushed

fully home, not at a slight angle. Failure to

check this may again result in disaster.

Fig. 2: Connecting the ribbon cable to the bus

board.

D Now fix the module solidly in its case.

D Re-connect the A-100 MNT’s power supply, and

then switch on the mains again.

D Test out the newly installed module.

If it doesn’t seem to be working as expected, imme-

diately disconnect the system from the power sup-

ply again.

In this case, double-check the connections, making

completely sure that the ribbon cable is the right

way round where it connects to the module and to

the bus.

Best ückungsseite

Busplatine

components side

bus board