Owner manual

doepfer

System A - 100

Analog Meter

A-197

1. Introduction

Module A-197 serves to display DC or AC voltages

by means of an illuminated moving coil meter with

mirror scale.

The display range is 0...+10V (resp. -5V...+5V in the

offset mode).

The module features 3 different measuring methods

that are selected by a toggle switch.

A LED is used as an indicator for negative voltages.

A-197

VU Meter

Meas. Mode

Neg. Indicator

Met er

PAGE 1
System A - 100 doepfer Analog Meter A-197 1. Introduction A-197 VU Meter Module A-197 serves to display DC or AC voltages by means of an illuminated moving coil meter with mirror scale. The display range is 0...+10V (resp. -5V...+5V in the offset mode). In Meter The module features 3 different measuring methods that are selected by a toggle switch. A LED is used as an indicator for negative voltages. Neg. Indicator Meas.
PAGE 2
A-197 Analog Meter System A - 100 doepfer Controls: 2. Overview 1 Meter : Moving coil meter 2 Meas.
PAGE 3
doepfer System A - 100 3. Controls 1 Meter The illuminated moving coil meter with mirror scale is used as readout for the voltage applied to socket !. 2 Measurement Mode This switch is used to select the desired measurment mode: Analog Meter A-197 • Direct mode In this mode the incoming voltage is lead to the meter without additional electronic modification. This mode is intended to display positive DC voltages, e.g.
PAGE 4
A-197 Analog Meter System A - 100 3 Neg. Indicator 4. Inputs / Outputs The LED lights up if a negative voltage appears at the measurement input !. ! In doepfer This socket is the measurement input of the module. It is available as a triple multiple so that the signal to be measured can be used elsewhere in the system simultaneously.