Instructions / Assembly

3/4
minimum
Determine where your track will be located, then
mark and pre-drill holes.
1 - Mark a level line at the
correct height (H + 1
5/8
”).
2 - Find location of studs in 2 - Find location of studs in
your wall. (NOTE: If studs
cannot be found at spacing
where track is to be installed,
it is recommended to install a
header board.)
3 - Mark and pre-drill holes 3 - Mark and pre-drill holes
corresponding to the location
of studs along the level line.
NOTE:
H = height of your
barn door in inches
IMPORTANT!
Before begining
installation, please
read through all of the
suggestions and
measurements
provided in this
document.
document. They are
guidelines, and may
require modification
based on your specific
situation. Though it
can be done yourself,
a contractor is
recommended.
recommended.
Install track by driving lag screws through
washers, track, and spacers.
Attach anti-jump discs on top of door.
Drill holes in door and attach rollers.
Stops can be placed on
either side of outer holes.
After attaching anti-jump discs on top of door,
rotate them toward the front side of door.
optional T
floor guide
lag screws
with optional drywall anchors
M10x55mm (x4)
for 35-40mm door
1/4
1/4
U channel
floor guide
door
stops
spacers
washers
track
anti-jump
discs
plugs
rollers
Sliding Barn Door - Suggested Installation Instructions
H + 1
5/8
H + 1
5/8
78
3/4
17
3/4”
17
3/4”
17
3/4”
17
3/4”
17
3/4”
17
3/4”
17
3/4”
17
3/4”