User's Manual

TESTING YOUR DOGTRA E-Fence 3500 PRIOR TO
INSTALLATION
1. To ensure that your E-Fence 3500 system is working properly, connect the transmitter
adaptor into the adaptor of the transmitter and then plug the adaptor into a household
outlet. Switch the stimulation knob to Pager+Stimulation, or Stimulation Only. The ON/OFF
indicator light should turn on.
2. Unwind the length of ground wire that was provided and strip about 1/2 inch off each
end. Insert both ends of the ground wire into the outer, red wire connector jacks, leaving
the center jack free. If the wires are connected properly, the wire indicator light will be on.
3. Next, activate the receiver/collar by turning the intensity level dial on the receiver to the
desired level. The LED light will blink once every two seconds showing that it is on.
* If not activated for 10 seconds or more, the system will go into sleep mode.
4. Hold the receiver in your hand with the contact points facing up. Place the test lamp over
the contact points and approach the test loop.