User's Manual

Wire Connectors For Splicing
The easy-to-use push-release wire connectors let you instantly connect or disconnect the
boundary wire leads. Wires should be stripped approximately a half-inch before being
inserted intothe red connectors on the bottom of the wall mount transmitter.
The system comes with a ground wire to protect the unit in the event of lightning/power
surge. Strip about a half-inch on each end of the ground wire and insert one end into the
black connector on the bottom of the wall transmitter. The other end should be buried into
the ground or wrapped around a water pipe and secured with electrical tape.
Option : A lightning/surge protector can be purchased if there are no grounding options
near the wall transmitter.