Owner`s manual
12 13
To activate the light-locate mode, hold down the front transmitter button.
The location light will continuously ash while the button is pressed, up
to 12 seconds.
To activate the light-tracking mode, tap the front button on the
transmitter once.
The receiver/collar LED location lights will now blink every 3 seconds.
To deactivate the light-tracking mode, tap the front button on the
transmitter once more.
3. Collar tting
The collar should be t so that the surgical stainless steel contact points
are pressed rmly against the dog’s skin. With a proper t, you should
be able to insert a nger or two snugly in between the contact points
and your dog’s skin. The best location for the receiver box is on either
side of the dog’s windpipe. The receiver box should stay in this position
during any training or exercise. If the unit slips downward towards the
dog’s windpipe, the unit was NOT fastened rmly enough.
A loose fitting collar can cause the contact points to rub against the
skin and cause irritation. If the collar is on too tight, the dog may have
difculty breathing. ALWAYS check your dog’s neck for signs of skin
irritation when using an e-collar. If any signs of skin irritation are found,
suspend e-collar training and consult with a veterinarian.
L (Light)
High intensity LED location
lights on the EDGE receiver/
collar helps to find and
distinguish dogs easily in low
light/dark conditions.
The buttons on the front of the transmitter enables
control of up to 4 receivers/collars. Each of the 4
buttons on the transmitter can be coded to operate
a different receiver/collar. The receivers/collars can
be distinguished by coding the transmitter button
to the matching receiver/collar strap color.
Additional receivers/collars with straps are
available online at shop.dogtra.com or by calling
customer service at 1-888-811-9111.