Owner's Manual

3534
The PATHFINDER(PT10U) complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
This is a sensitive radio device. Any unauthorized changes or modifications to this
device that are not expressly approved by Dogtra will void the warranty and may void
the user's authority to operate the equipment.
Please do not tamper or modify the unit.
Radio Frequency Radiation Exposure for PT10U
This device is a mobile transmitter and receiver that uses an external antenna to send
and receive low levels of radio frequency (RF) energy for data communications. The
device emits RF energy below the published limits
when operating in its maximum output power mode and when used with Dogtra Co.
authorized accessories.
FCC WARNING
5. My dog has skin irritation.
- This may be due to an improper fit or from wearing the receiver too long. If
your dog exhibits signs of skin irritation, consult with a veterinarian. Once
your dog’s skin returns to a normal condition, continue to use the receiver and
check your dog’s neck each time you use the unit.
It has been tested and found to comply with RCM standards.
EXTENDED LIMITED WARRANTY
For Certain Dogtra Products Purchased from Dogtra Authorized Dealers
1+1 Year Extended Warranty
Except as otherwise provided, Dogtra warrants to the original retail purchaser
(“You”) that your Dogtra product shall be free of defects in materials and
workmanship for a period of one (1) year from the date of purchase (“Original
Warranty”). As a special promotion, Dogtra further warrants that your Dogtra
product shall be free of defects in materials and workmanship for an additional
one (1) year from the date that your original warranty expires (“Extended
Warranty”). The Original and Extended Warranties cover the cost of repair
(parts and labor) or replacement (if repair is not feasible) of a defective Dogtra
product during said warranty periods. For such repaired or replaced products,
the remaining portion of the warranty periods, or ninety (90) days, whichever
is longer, shall apply. Dogtra, at its sole discretion, shall determine whether
to repair or replace a product covered by the Original Warranty or Extended
Warranty.
Warranty Conditions
The Original and Extended Warranties are not transferrable and apply to your
Dogtra product only if:
(1) You are the original retail purchaser of the product,
(2) You bought the product from a Dogtra Authorized Dealer, and
(3) You present a receipt or other proof of purchase showing a valid purchase
date, the name and address of the Dogtra Authorized Dealer, and the
purchased product identified by model and/or serial number.
Warranty Exclusions
The Original and Extended Warranties do not cover damage, loss, or
deterioration to your Dogtra product caused: by misuse, neglect, abuse, or other
improper handling of the product; by failure to follow use or care instructions;
by use of the product for other than its intended purpose; by accident or natural
forces such as fire or flooding; or by normal wear and tear such as scratches to
the product surface.
The Original and Extended Warranties also do not cover Dogtra products that:
are purchased from non-authorized dealers; are purchased outside of the United
States or Canada; have been damaged during shipment (even if Dogtra paid or
arranged for shipping); have been modified or tampered with in any manner;
are opened or repaired by anyone other than Dogtra; or have serial numbers
that have been altered or defaced.
DOGTRA EXTENDED PRODUCT WARRANTY
Radio Frequency Radiation Exposure for PC10U
To comply with RF exposure compliance requirements, the device should be installed
and operated with a minimum of 0.20 m between the device and your body. The device
should not be used in other configurations. This device must not be co-located or
operated in conjunction with any other transmitter or antenna.
Radio Frequency Radiation Exposure for PR10U
To comply with FCC RF exposure compliance requirements, a separation distance of at
least 0.25 m must be maintained between the antenna of this device and all persons.
This device must not be co-located or operation in conjunction with any other antenna
or transmitter.
Any changes or modifications (including the antenna) made to this device that are not
expressly approved by the manufacturer may void the user’s authority to operate the
equipment.
The antenna used for the PR10U has a whip antenna shape but it is not a general
connecter type of antenna and it is specially designed for use with the PR10U only.
The connection part of the PCB is a hole type, and it is fixed to the PCB by bolts and
soldering. Furthermore, this product has antenna cover, it is designed to be lockable
and it can’t be open without specified tool.