Owner's Manual

3736
1. CHARGING THE PATHFINDER2
Fully charge the PATHFINDER2 GPS connector and receiver before the first use.
The PATHFINDER2 uses lithium polymer batteries.
• Only use official Dogtra chargers with the PATHFINDER2.
• Do not charge the PATHFINDER2 near flammable substances.
• Fully charge the PATHFINDER2 if storing for 1 month or longer.
When to Charge
• When the LED is red on the GPS connector or receiver.
• When the app displays low battery for the GPS connector or GPS receiver.
• When the LED on the transmitter or receiver will not come on.
How to Charge
1. Connect the charger to the GPS connector and receiver using the splitter
cable.
2. Plug the charger into a 120-volt outlet.
3. When fully charged, detach the cables and plug the rubber caps over the
charging ports on the GPS connector and receiver.
4. The LED will display red while charging and green when the unit is fully
charged. A depleted battery requires 3.5 hours to fully charge.
PRODUCT MAINTENANCE
Splitter Cable
Do not use more than one splitter cable with a single battery charger.
The Dogtra PATHFINDER2 comes with 5/8” contact points that can be extended
to 3/4” for dogs with longer coats.
To increase the length:
1) Use the included adjustment tool side marked 5/8” to unscrew the contact
points counter-clockwise.
2) Place the extension over the exposed threads, flat side down.
3) Place the contact points over the extensions and tighten clockwise using the
adjustment tool side marked 3/4”.
Caution!
Tighten until firmly in place. Be careful not to over tighten.
To shorten the length back to 5/8", use the adjustment tool marked 3/4" to
remove the extensions and then tighten the contact points clockwise using
the side marked 5/8".
2. CHANGING THE CONTACT POINT LENGTH