User Manual

20
®
Every transmitter comes with two dog-capability. Your transmitter is pre-set for use
with one dog but can easily be programmed for use with two dogs.
To use the BigLeash Remote Trainer with two dogs, you must have a receiver collar
for the second dog (Collar 2). Collar 2 is not included with the system for the first
dog; it must be purchased separately.
Collar 2 comes with a bright orange collar strap and has a small “Dog 2” sticker on
the back so that you can easily differentiate Collar 1 from Collar 2.
Programming the Collar 2 Receiver
(Also referred to as “marrying” the transmitter and the receiver.)
1. Before adding Collar 2 to the transmitter, charge it for at least 3 hours.
2. Make sure the transmitter and both the receivers (Collar 1 and Collar 2)
are turned ‘off’.
3. With the transmitter and the receivers turned “off”, hold down the ‘A’
button for 10 seconds until the screen on the transmitter turns ‘on’.
4. Set the
CORRECTION LEVEL to ‘2’.
5. Press and hold down the Collar 2 button while turning the new
receiver ‘on’ by aligning the receiver next to the transmitter at the
alignment markers (see page 3).
6. Continue to hold the receiver next to the transmitter at the alignment
markers while holding down the Collar 2 button. You will hear a series
of beeps.
7. When the series of beeps stops, move the receiver away from the
transmitter.
8. The second receiver is now programmed to the Collar 2 setting.
9. Turn the transmitter and receiver “on” in the usual way to use.
Using the Remote Trainer with Two Dogs
■
The Collar 1 and Collar 2 buttons allow you to change commands between
the two collars. The transmitter will store the most recent settings for
each collar.
■
When working with two dogs, the display on the LCD screen will indicate if
the transmitter is set to send the signal to Collar 1 or Collar 2.
Adding a Second Receiver Collar