User Manual

Turning the Transmitter and Receiver “ON” and “OFF”
■
Both the transmitter and receiver must be turned “on” to operate.
■
To turn the transmitter and receiver “on” or “off”, hold the transmitter and
receiver next to one another aligning the markers (indicated below) and slide
the markers past each other along the seams.
■
When the transmitter turns “on”, the screen light will turn on. When the
receiver turns “on”, you will hear an audible low-to-hi “beep” tone.
■
Follow the same procedure to turn “off” the receiver and the transmitter. The
receiver will make a hi-to-low “beep” tone when turned off. Turning your
system “off” will help to preserve the battery life.
✧ We recommend turning the system “off” when not in use. ✧
Charging the Transmitter and Receiver Batteries
■
Battery
•
Both the transmitter and receiver use a rechargeable Lithium polymer
battery. Both units should be fully charged before use.
•
For battery replacement information, see the Warranty on page 16.
•
Recharge your batteries on a regular basis. It takes approximately 3-4
hours to fully charge a battery. With typical use, the charge
should last approximately three days.
■
Recharging the Battery
•
To recharge the transmitter and/or the receiver, insert
the power adaptor plug into the recharging port.
•
When the transmitter and/or receiver is charging, the
LCD screen remains “on” and the battery icon turns
solid. When charging is complete, the battery icon
disappears.
6
ON/OFF
Magnetic Switch
{
{
Receiver
Alignment Markers
A “Y” connector is included so the power adaptor can be used
to charge both the transmitter and the receiver at the same time.
Transmitter
Alignment Markers