User's Manual

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This de vice ma y not cause harmful interference, and (2) this device must accept

any interference received, including interference that may ca use undesired operation.

Changes or modiﬁcations not expressly approved by DogWatch, Inc., could void the user’s

authority to operate the equipment.

This equipment has been tested and found to comply with the limit s for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one of the following

measures:

- - Reorient or relocate the receiving antenna.

- - Increase the separation between the equipment and receiver.

- - Connect the equipment in to an outlet on a circuit different from that to which the receiver is

connected.

- - Consult the dealer or an experienced radio/ TV technician for help.

This device complies with Industry Canada regulations.

Under Industry Canada regulations, this radio transmitter may only operate using an antenna of

a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce

potential radio interference to other users, the antenna type and its gain should be so chosen that

the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful

communication.

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject

to the following two conditions: (1) this device may not cause interference, and (2) this device must

accept any interference, including interference that may cause undesired operation of the device.

Conformément à la réglementation d’Industrie Canada, le present émetteur radio peut fonctionner

avec une antenne d’un type et d’un gain maximal (ou inférieur) approuvé pour l’émetteur par

Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à l’intention des

autres utilisateurs, il faut choisir le type d’antenne et son gain de sorte que la puissance isotrope

rayonnée équivalente (p.i.r.e.) ne dépasse pas l’intensité nécessaire à l’établissement d’une

communication satisfaisante.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio

exempts de licence. L’exploitation est autorisée aux deux conditions suivantes: (1) l’appareil

ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage

radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

For RF exposure - This portable equipment complies with FCC and Industry Canada RF radiation

exposure limits set forth for an uncontrolled environment. To maintain compliance, it must not be

co-located or operated in conjunction with any other antenna or transmitter.

This system is composed of three components:

(1) Transmitter SF-T-10 (2) Portal SF-P-10 (3) SmartCollar SF-C-10.