User Manual

LAMP REPLACEMENT
1. Allow lamp and unit to cool before attempting
to change the lamp.
2. Unplug cable from back of unit by rotating the
screw collar on the cable connector then,
holding connector body, pull the cable
connector from the unit.
3. Loosen the 2 brass screws located on the
front of the top cover.
4. With the screws loosened, rotate the top cover
locks downward in the slots in the cover.
5. Open the top
cover.
6. Firmly grasp the lamp and
slide it up from behind the
spring retaining springs.
7. Remove the lamp from the
lamp socket by holding the
lamp in one hand and socket
in the other and gently
rocking the socket until the
lamp comes free. Do not use
any tools to pry the socket
from the lamp.
Page 2
A240L / A241L
Grasp lamp
here to
remove
Lamp
Socket
WARNING
Hot Surfaces. Remove power plug before lamp
replacement and wait for hot lamp to cool.
Retaining
Springs
Grasp lamp here
to remove
Page 3
A240L / A241L
8. Discard the old lamp.
9. Remove the new lamp from its box being careful not to touch the lamp pins, the
inside of the reflector or the inner bulb. Touching these areas will significantly
reduce the lamp life.
10. Insert the pins of the lamp firmly and completely into the holes of the lamp
socket.
11. Slide the connected lamp into the lamp holder and behind the retaining
springs.
12. Close the top cover, rotate the cover locks upward and tighten the 2 brass
screws.
13. Reconnect the cable and the unit is now ready for use.
Handle only
in these areas
Do Not Touch
REPLACEMENT PARTS
Part No. Description
686009-02468 EKE, Halogen Lamp
LIFETIME WARRANTY ON LIGHT SOURCES
Dolan-Jenner Industries, Inc. (DJI) warrants its products to be free from defective material and workmanship.
Any light source or parts thereof which are determined by DJI to be defective within ten years (average product life
cycle) from shipment date will be replaced or repaired at our option. This policy is effective Nov. 1, 1993 and is not
retroactive. All fiber optics are warranted for one year. This warranty specifically excludes both incandescent and
quartz-halogen lamps, and optical filters.
Any products which, in our opinion, have been subjected to misuse, incorrect wiring, or where installation
procedures are not in accordance with the instruction manual, are excluded from this warranty. Nor does this warranty
extend to products on which repairs or alterations have been made outside the factory, or on which the identification
or serial number has been altered or to accessories not of our manufacture.
Our obligation with respect to products or parts covered by this warranty shall be limited to repair or replacement,
F.O.B., Lawrence, Massachusetts. In no event shall DJI be held liable for consequential or special damages, or for
transportation, installation, adjustment, or other expenses which may arise in connection with such products or parts.
This warranty is in lieu of all other statements or warranties or guarantees, written or implied, by DJI or its authorized
representatives.
Important: Please contact factory for a return authorization number prior to shipping merchandise to factory.