Manual

Risk of electrical shock. Illuminator should be in upright position and remove power cord before Fuse replacement.
WARNING
Replace the fuse with the correctly rated fuse as listed on the label on the back of the illuminator. Use of an improper
fuse can create a hazardous condition.
Fuse Replacement
1) Press the ON(1)/OFF(0) switch to the OFF(0) position.
2) Remove the AC line cord from the power entry module at the rear of the illuminator.
3) The fuse drawer is part of the power entry module. The drawer is located directly beneath where the AC line cord
plugs in.
4) Remove the fuse drawer. Only one fuse is required. Remove the blown fuse from the drawer and discard.
5) Place the replacement fuse into the fuse holder by inserting either end of the fuse into the fuse holder.
6) Push the fuse drawer until it "clicks" into position.
7) Attach the AC line cord to power entry module at the rear of the illuminator.
8) The illuminator is now ready for service.
Replacement Parts
Mfg Part No. 020153203200 Fuse, 2A, 5 x 20, 250 V, slow blow
Only above parts are replaceable. Return illuminator to factory for warranty service. Any attempt to open the unit or
replace other parts voids warranty.
Performance Statement
Dolan-Jenner Industries, Inc. (DJI) recognizes that its illuminator products may be used under an almost unlimited variety
of conditions. As such, we are prepared to assist the customer in the selection and application of any of these products.
This includes application engineering, sample testing and other means as determined by DJI. Where DJI has made
specific recommendations for its products, systems, or detection techniques (based on complete and detailed information
furnished by the customer) we will extend every effort to assure that the customer is satisfied with the performance of our
products. Continual development and improvement of DJI products may require changes in details that do not coincide
with descriptions or illustrations shown. All fiber optic cable diameters are nominal.
Two Year Warranty on Light Sources
Dolan-Jenner Industries, Inc. (DJI) warrants its products to be free from defective material and workmanship. Any light
source or parts thereof which are determined by DJI to be defective within 2 years from shipment date will be replaced or
repaired at our option. All fiber optics are warranted for one year. This warranty specifically excludes fuses.
Any products which, in our opinion, have been subjected to misuse, incorrect wiring, or where installation procedures are
not in accordance with the instruction manual, are excluded from this warranty. Nor does this warranty extend to products
on which repairs or alterations have been made outside the factory, or on which the identification or serial number has
been altered or to accessories not of our manufacture.
Our obligation with respect to products or parts covered by this warranty shall be limited to repair or replacement, F.O.B.,
Boxborough, Massachusetts. In no event shall DJI be held liable for consequential or special damages, for
transportation, installation, adjustment, or other expenses which may arise in connection with such products or parts.
This warranty is in lieu of all other statements or warranties or guarantees, written or implied, by DJI or its authorized
representatives.
Important: Please contact factory for a return authorization number prior to shipping merchandise to factory.