Installation manual

Dolby
®
Model CP650 Installation Manual Software Operations
A-2
Update Failed!
Reconnect and update
Software to proceed.
A.2 Updating CP650 Software
1. Connect the PC to the CP650 Cinema processor using a serial cable connected to
the CP650 serial data connector on the front setup panel (or on the rear panel).
Mic Bypass
Video
Clamp RTA1 RTA2
123 7456 8
SIGNAL
PRESENT
Lt
Rt
Lt Rt
SwLCRLsRs
SERIAL DATA MIC MUX
2. Run the CP650 Setup Software on the PC.
3. From the “Action” menu, choose “Connect”, or click on the connect icon.
4. If prompted, choose to “Retrieve” cinema processor settings.
5. From the “Action” menu, choose “Update Software...”.
6. If desired, you may save the newly retrieved settings to disk.
7. Browse for and select the software update file (.bin) to be used for updating the
CP650.
8. Select “Update Now”.
Note: This process should not be interrupted. If the connection is lost during the
update process, the CP650 displays:
If this occurs, you must reconnect the CP650 Setup Software and restart the
software update process. If the software update is not completed successfully
before the CP650 main power is turned off, the CP650 will become inoperable
and the Cat. No. 797 flash memory module must be replaced.
9. When the update has finished, the CP650 will automatically restart.
10. Next, the CP650 Setup Software will automatically reconnect, send the cinema
processor settings back, and remain connected.
The update process is now complete. The CP650 will contain updated software while
retaining your original alignment settings.