Installation manual

Dolby
®
Model CP650 Installation Manual A-Chain Alignment
5-5
M
anua
l
L
O
O
R
Level O O
P1
O O
XX
XX XX
XX O O
M
anua
l
L
O
O
R
Level O O
P1
O O
O O xx
xxxx
xx
Saving Changes.....
...
M
anua
l
Optical Level Adjust
Projector 2
Projector 2Projector 2
Projector 2
Press OK when ready.
OK
Press the OK button to begin manual
adjustment.
The number displayed on the bottom line
represents the level setting for Left channel.
The four vertical circles display the Left
channel signal level, similar to an LED meter.
Rotate the front-panel knob until the two center
circles fill black.
Press the center menu button to select the Right
channel.
The number displayed on the bottom line will
move the Right-channel column.
Rotate the front-panel knob until the two center
circles fill black.
OK
Press the OK button to save the level settings.
Proj 2
Stop the projector and load/run Cat. No. 69T
film loop on projector 2, if so equipped.
menu
OK
Press the left menu button to move the
displayed menu to Manual Optical
LevelAdjust for projector 2.
Repeat the above procedure for the Left and
Right channels.