Installation manual

Model DMA
™
8 Installation Manual Setup
3-2
3.2 Running Setup
After installing the software, run it to establish the connection between your PC and
the DMA8. The Open Device screen appears:
Figure 3-1 Open Device Screen
3.2.1 Main Screen
For initial DMA8 setup, bypass this screen by selecting Change Settings.
Figure 3-2 Main Screen
This screen is used to monitor all aspects of operation. Settings cannot be changed on this
screen. Also, the screen provides remote troubleshooting information via the Internet.
For future use
For communicating with DMA8
For running the software without
connecting to the DMA8, or for entering
setup parameters and saving for later use
See Section 3.2.2.
Use a previously-saved
.dby setup parameters file.
Save a new .dby file.
Go to the initial software
startup screen (establish a
connection).