Inc. Multichannel Audio Encoder User's Manual DP569

Model DP569 User’s Manual Front-Panel Menus
4-5
LCD Description
Lt/Rt C Dwnmx
When the stereo downmix is Lt/Rt, designates downmix level for center channel
when end user has no center speaker.
Lt/Rt S Dwnmx
When the stereo downmix is Lt/Rt, designates downmix level for surround
channels when end user has no surround speakers.
Lo/Ro C Dwnmx
When the stereo downmix is Lo/Ro, designates downmix level for center channel
when end user has no center speaker.
Lo/Ro S Dwnmx
When the stereo downmix is Lo/Ro, designates downmix level for surround
channels when end user has no surround speakers.
Dolby Srnd EX
Identifies if audio is encoded as Surround EX and requires Surround EX decoding.
A/D Conv Type
Identifies the setting for type of A/D converter. Informational only.
De-emphasis
Parameter controls whether or not 50/15 µs digital de-emphasis is applied to the
main input channels.
DC Filter
Applies a DC-blocking 3 Hz highpass filter before Dolby Digital encoding.
Lowpass Filt
Applies a lowpass filter to the main input channels before Dolby Digital encoding.
LFE Filter
Applies a 120 Hz lowpass filter to LFE channel before Dolby Digital encoding.
Srnd 3dB Attn
Attenuates surround channels 3 dB before encoding.
Srnd Ph Shift
Before encoding, creates the phase-shifted surround channels necessary to create
an Lt/Rt output in a decoder that can be Pro Logic decoded to L, C, R, S.
4.2.4 User Presets
Allows the user to save and recall 32 individual unit configurations. Presets 28–32
contain presets stored in factory ROM. When shipped from the factory, presets 1–5
contain a copy of presets 28–32. Each preset can be given a name of up to 12 characters.
A table of factory default presets can be found in Appendix C.
Preset Pending
A special recall preset state allows a selected preset to be recalled at a time, based on
the timecode input. When this has been enabled, the selected preset will be
considered pending until the specified time is reached, and the preset becomes active.
For instance, you might want the Stereo Music preset to take effect at timecode
00:12:22:12.
To do this, use the following procedure:
• Enter 00:12:22:12 in the TC Start Time field
• Recall the Stereo Music preset.
• Choose Yes when asked Recall at Start?
When timecode 00:12:22:12 occurs, the unit will switch to the Stereo Music preset.
There are a few restrictions on the recall preset on timecode feature:
• Once you have selected a start time and a preset, you can’t change the start
time.