Operation Manual

Replacing the starter cable

- Thread in a new cable (4 mm/.16" dia. x 1000 mm/39" long)

as shown in Figure B and tie the ends as shown.

- Pull knot (B/1) into the cable pulley (B/3).

- Pull knot (B/2) into the cable grip (B/4).

- Wind the cable around the pulley in the direction shown by

the arrow. Pull the cable out from the pulley by the grip, then

hold the pulley Þ rmly and wrap the cable around it another

three times.

CAUTION: Danger of injury! Secure the cable grip when

pulled out! It will whip back if the cable pulley is released

by accident.

NOTE: With the cable pulled all the way out, it must still be

possible to turn the pulley another 1/4 turn against the return

spring.

Replacing the return spring

- Remove the fan housing (see above under "Replacing the

starter cable").

- Take off the circlip (C/1) and washer (C/2) (circlip pliers,

see "Accessories").

- Remove the cable pulley (C/3).

- Unscrew screws (C/4) and carefully remove spring housing

(C/5) with spring.

CAUTION: Danger of injury! If the spring is broken it may

pop out!

NOTE:

The old spring and spring housing should be recycled.

Replacement springs come already installed in a new spring

housing. Before installing, grease the spring lightly with mul-

ti-purpose grease, order No. 944 360 000.

- Assemble in reverse order. When putting the cable pulley

back on, turn it slightly until you feel it catch.

- Wind on the starter cable as described above under "Re-

placing the starter cable."

Mounting the fan housing

- Push the tab (D/1) extending out from the edge of the fan

housing (D/3) under the hood (D/2).

- Position the screw holes.

- Push the fan housing (D/3) gently and pull the starter grip

until the starter catches.

- Screw in the four fastening screws tightly.

- Unscrew the four screws (A/1) holding down the fan hous-

ing (A/2). Lift the housing slightly, pull in the direction of the

arrow, and remove.

- Remove all pieces of cable.

RE Y