Service manual

21
DOLMAR GmbH
11 12
14
13
1
2
3
4
7
6
5
8
9 10
12
11
13 Cutting attachment
13-06 Replacing the guard stop
Knock the shaft (1) with a pin out of the handle
(2). In assembly, push the new handle onto the
shaft until the shaft is flush with the outside
edge of the handle.
13-07 Replacing the fixing screws
Push the screws (3) out of the housing. Before
inserting, wet the stop area (arrow) on the
screws with glue 980.009.000.
13-08 Removing the cutting device bear-
ings
Warm housing, remove ball bearings, spacer
sleeve and guard rings from the housing.
13-08 Mounting the cutting device bearings
Mount external guard ring (4). Heat housing up
to approx. 100°C. Push ball bearing (5) up
against the ring. Insert middle ring (6) and
spacer sleeve (7), then push second ball
bearing up to ring.
13-00 Adjusting the cutter guard holding
attachment
If the guard is subjected to high stresses , the
holding attachment and the guard may no
longer be aligned (arrow). for correction loosen
screw (8) and adjust holding attachment
(see picture 13-02/13-05, page 20).
13-00 Tensioning the V-belt
After mounting the cutting device, tighten the
nuts (9) by hand. Turn the screw (10) until the
square nut (11) is aligned with the marking (12)
on the hood. Tighten the nuts with 20Nm.