Service manual

6
DOLMAR GmbH
1
2
3
4
04 Ignition system
02-02 Mounting the clutch/drum
When mounting the drum and the clutch, be
careful to mount the washers in the right order.
(1) Ring (sits in the groove of the crankshaft)
(2) End collar (with recess towards ring)
02-02 Dismantling the clutch/drum
Unscrew the clutch with the special tool (parts
no. 944.500.570) and a 19mm wrench.
Caution: left-handed thread
02-02 Mounting the clutch/drum
(3) Guide washer
(4) Clutch guide washer,before assembly,
press into the support on the back of the
clutch hub.
02-01 Repairing the clutch
The tension springs of the clutch can be
removed/ replaced with pointed pliers. If
spares are required, the 3 tension springs
are only available as individual parts.
02-02 Mounting the drum
Before installing the clutch drum, the needle
bearing that is pressed in must be greased.
(Multipurpose grease 944.360.000)
02-01 Repairing the clutch
The tension springs should only be replaced
as a set if replacement is required.
If the hub / fly weight is defective, the com-
plete clutch must be replaced.