User`s guide

Dolphin® 9500 Series User’s Guide Rev D
11/8/06
7 - 3
Current TX Rate Shows the current transmit rate. This can be 1 Mbps, 2 Mbps, 5.5 Mbps, or 11 Mbps.
Disable/Enable
Radio
Tap this button to disable/enable the radio.
Rescan Tap this button to start a rescan process to search for an AP with a stronger signal in the network.
Link Quality Displays the signal to noise ratio.
Strength Displays the signal strength at the receiver.
IP Address Displays the IP address of the radio. Verify configuration information with your network administrator.
Renew IP Tap this button to reapply the IP address from the DHCP server when automatic DHCP is enabled.
State Displays the Network Name and the MAC address of the:
• AP the radio is associated with in AP mode, or
• Creator of IBSS into which the radio is joined in peer-to-peer (Ad-Hoc) mode.
After an SSID is chosen, this field name changes to “BSS ID.”
More Info Tap this button to display detailed TCP/IP information as shown in the following screen.
Ping Tap this button to open the Ping Utility window where you can ping IP addresses.
Field Description
IP Address Enter an IP address to ping.
Size (Bytes) The current data packet size in bytes; 32 is the default.
You can select up to 8192 from the drop-down list.
Timeout (ms) The current timeout; 500 is the default.
Increase or decrease it by tapping the up and down arrow buttons.
Clear Clears IP Address input and the ping statistics field.
Ping Pings the IP address entered in the input field.
Ping Statistics Displays the pinging IP address and the pinging results.
Field Description