Specifications

MC55 AT Command Set
13.11 AT+CNMI
s
MC55_ATC_V03.03 Page 334 of 459 9/9/05
Confidential / Released
URC 4
<bm>=2 (PDU mode enabled):
+CBM: <length>
<CR><LF><pdu>
Indicates that new cell broadcast message has been received
URC 5
<bm>=2 (text mode enabled):
+CBM: <sn>, <mid>, <dcs>, <page>, <pages>
<CR><LF><data>
Indicates that new cell broadcast message has been received
URC 6
<ds>=1 (PDU mode enabled):
+CDS: <length>
<CR><LF><pdu>
Indicates that new SMS status report has been received
URC 7
<ds>=1 (text mode enabled):
+CDS: <fo>, <mr>[, <ra>][, <tora>], <scts>, <dt>, <st>
Indicates that new SMS status report has been received
URC 8
<ds>=2:
+CDSI: <mem3>, <index>
Indicates that new SMS status report has been received
Parameter Description
[0]
(&F)
Buffer unsolicited result codes in the TA. If TA result code buffer is full, indica-
tions can be buffered in some other place or the oldest indications may be dis-
carded and replaced with the new received indications.
1 Discard indication and reject new received message unsolicited result codes
when TA-TE link is reserved (e.g. in on-line data mode). Otherwise forward
them directly to the TE.
2 Buffer unsolicited result codes in the TA when TA-TE link is reserved (e.g. in
on-line data mode) and flush them to the TE after reservation. Otherwise for-
ward them directly to the TE.
3 Forward unsolicited result codes directly to the TE. TA-TE link specific inband
technique used to embed result codes and data when TA is in on-line data
mode.
Rules for storing received short messages depend on the relevant data coding method (refer to GSM 03.38),
preferred memory storage (AT+CPMS) setting and this value.
Note: If AT command interface is acting as the only display device, the ME must support storage of class 0 mes-
sages and messages in the message waiting indication group (discard message)
[0]
(&F)
No SMS-DELIVER indications are routed to the TE.
1 If SMS-DELIVER is stored in ME/TA, indication of the memory location is
routed to the TE using unsolicited result code:
<mode>
(num)(&W)
<mt>
(num)(&W)(&V)