Specifications

MC55 AT Command Set
2.13 AT^SCFG
s
MC55_ATC_V03.03 Page 53 of 459 9/9/05
Confidential / Released
Power saving mode 9 timeout
This parameter can be used to query or configure the wake up time for power saving mode 9 (see AT+CFUN with
parameter <fun>=9). The granularity of the timeout value is 100ms (i.e. a value of 10 equal 1 second). The min-
imum timeout value that can be applied is 5, but accuracy is only guaranteed for timeout values greater than 20.
Parameter is global for the ME, volatile and will not be reset by AT&F.
5...20
(P)
...36000
Call Handover Status
This parameter offers a workaround to prevent problems during call handover into the 1900 MHz (or 1800 MHz)
band, caused by non-conforming configurations of the 1900 MHz (or 1800 MHz) GSM network.
“0“
(P)
Disable workaround.
“1“ Enable workaround. This value should be selected when handover into a 1900
MHz (or 1800 MHz) GSM network fails. If required for permanent use the value
needs to be set each time the ME is restarted.
CIEV Call Status Indication
This parameter can be used to control the behaviour of URC "+CIEV: call". See also AT+CIND, AT+CMER and
Section 7.1, Call Status Information.
Parameter is global for all interfaces and will not be reset by AT&F.
“restricted“
(P)
URC "+CIEV: call" will be issued only when a Call Status transition ends in
state "active" or "unknown" (see Section 7.1, Call Status Information) for a call
in the list of active calls.
“verbose“ URC "+CIEV: call" will be issued when any state transition (including transi-
tions beginning or ending in state "unknown") occurs in the list of active calls,
or when a traffic channel is established.
SLCC Call Status Indication
This parameter can be used to control the behaviour of URC "^SLCC". See also AT^SLCC and Section 7.1, Call
Status Information.
Parameter is global for all interfaces and will not be reset by AT&F.
“restricted“ URC "^SLCC" will be issued only when a Call Status transition ends in state
"active" or "unknown" (see Section 7.1, Call Status Information) for a call in the
list of active calls
“verbose“
(P)
URC "^SLCC" will be issued when any state transition (including transitions
beginning or ending in state "unknown") occurs in the list of active calls, or
when a traffic channel is established.
URC RING line
This parameter can be used to control the behaviour of the RING line to indicate URCs (both for idle interfaces
and, if configured by the parameter "URC/Datamode/Ringline", if link is reserved) and, if configured, the indicator
for incoming IP packets (see parameter "GPRS/RingOnIncomingData" (<groid>).
Parameter is local for the interface, volatile and will not be reset by AT&F.
“off“ URC is not indicated by RING.
<psm9to>
(str)(+CSCS)
<HandOverStatus>
(str)(+CSCS)
<succ>
(str)(+CSCS)
<sucs>
(str)(+CSCS)
<uri>
(str)(+CSCS)