English 1 DOLPHIN SUPREME M4 EN FR IT SP DEU User Instructions Guide d’utilisation Istruzioni per l’uso Instrucciones para el Usuario Bedienungsanweisungen 8151146 Ver.
English
English 1 What You’ll Find Inside the Box Part X Base frame for filter elements 2 Ultra-fine filter 4 filters Bag for filters storage 1 Spring filter 4 filters Power supply unit 1 Dolphin pool cleaner 1 Caddy kit 1 Comment Filter and cartridges Dolphin pool cleaner Optional components available on request from your Dolphin distributor Power supply unit Section 1 - Description of Main Components 1. Filters There are two types of filters.
English 2 3. Power supply unit Digital, “Switch-Mode” power supply: • • • • • Input - 100-250 AC Volts 50-60 Hertz 180 Watt Output - 30 VDC IP 54 ON On/Off switch Section 2 – Dolphin Operation Part 1 – Preparing the Dolphin pool cleaner for use A. Assemble the Caddy kit – you will find the instructions in a separate document B. Adjusting the handle float angle The Handle angle must be adjusted to determine the speed that the Dolphin advances along the water-line. 1.
English 3 C. Laying out the cable Unwind minimal required cable to cover the entire pool size, straight the cable along the pool side. Make sure there are no twists or kinks. 3 Meters 10 feet Optional Swivel Use only the original supplied power supply unit. The power supply unit is splash proof – do not immerse it in water. Unplug the power supply unit before any servicing activity. Do not plug the power supply unit in before placing the pool cleaner in the water.
English 4 Turning the Dolphin ON 1. Plug the floating cable from the Dolphin into the power supply unit. 2. Plug the electrical cable from the power supply unit into the mains. 3. Press on the ON/OFF switch. 4. The Dolphin will now start to work. Floating cable ON On/Off switch Note: If your model includes the remote control unit, please refer to the included instruction leaflet. Important: DO NOT enter the swimming pool while the pool cleaner is working.
English 5 Section 3 - Routine Maintenance Part 1 - Extracting and cleaning the filter elements Unplug power supply before any servicing activity. 1 2 3 Reassemble Insert the locating tabs at the bottom of the filter element into their groves on the base frame, then close the “S” clip.
English 6 Reinstall the filters according to the diagram DO NOT FORCE THE FILTERS INTO PLACE. Grooved end fitting Octagonal end fitting Important: Where applicable, you must reset the full filter bag indicator on the power supply unit. Recommendation: Rinse all brushes with clean water after each cleaning cycle. Part 2 - Dismantling and cleaning the impeller Unplug power supply before any servicing activity.
English 7 Helpful hints for better scanning of your pool The floats can be moved side-ways along the handle groove housings. To Move the floats in their handle housing grooves 1. Push float outwards. 2. To move the floats back to their original position, while pressing the release button on the base of the float, push the float back. Release Button There are three possible float configurations: Floats default position If turns while scanning less than 90º, pull out left float.
English 8 Troubleshooting Guide Before contacting your Dolphin distributor please read through this guide. The pool water condition must be within the following parameters: PH: 7.0 – 7.