User manual

EN
Using the inverter PerfectPower
12
6.2 Connecting the PP152 and PP154
!
A
The connection is made via a plug that is connected to a 12 V vehicle socket (for
PP152) and a 24 V vehicle socket (for PP154). The middle pin of the plug (fig. 1 4,
page 3) must be connected to the positive wire and the two side brackets of the plug
(fig. 1 5, page 3) must be connected to the negative wire.
6.3 Connecting the PP402, PP404, PP602 and PP604
!
➤ To set up the inverter, connect the red cable (fig. 1 4, page 3) to the positive
pole (+) of the battery and the black cable (fig. 1 5, page 3) to the negative
pole (–) of the battery. Make sure the vehicle battery terminals are clean when
connecting them.
7Using the inverter
The main switch (fig. 2 1, page 4) on the back of the device has three positions:
• ON: the inverter is switched on.
• OFF: the inverter is switched off.
• REMOTE: the inverter is switched on and off by an external switch.
➤ Connect your power consuming device, to the socket (fig. 1 1, page 3) of the
inverter.
Switching on at the device
➤ Set the main switch (fig. 2 1, page 4) to “ON”.
✓ The green LED (fig. 1 3, page 3) lights up.
WARNING!
The rating of the vehicle socket, the supply cable, and the fuse must be
at least 15 amps. Do not put in a fuse with a higher rating.
NOTICE!
Make sure that the plug is firmly connected in the vehicle socket. If the
connection is loose, the plug may heat up.
WARNING!
Do not reverse the polarity. Reversing the polarity of the connections will
cause a great spark and the internal fuses will melt.
PP150-PP400-PP600--IO-16s.book Seite 12 Mittwoch, 18. Januar 2017 1:13 13