User manual

EN
MWE820, 860, 890 Performing a functional test
11
MWE890
I
➤ Switch on the ignition.
➤ Press the button for longer than two seconds.
✓ The loudspeaker beeps repeatedly.
➤ Let go of the button.
✓ The system has been reset to the default settings.
9.4 Reflecting the display (MWE860 only)
If the obstacles are shown the wrong way round on the display, proceed as follows:
➤ Connect the sensor plugs into the sockets on the control module in the reverse
order (1 → 4, 2 → 3, 3 → 2, 4 → 1).
10 Performing a functional test
To test the parking aid, drive towards something slowly such as a wall.
A
NOTE
If the speedometer speed signal has been disconnected from the
control electronics, the default settings must be restored to ensure that
the sensors function correctly.
NOTICE!
Be very careful when you operate the device for the first time, and make
sure that you familiarize yourself with the various sequences of beeps
(fig. d).
MWE820-860-890-IO-16s.book Seite 11 Freitag, 26. August 2016 9:19 21