User manual

EN
Using MagicSafe MS660
44
Reactivating the alarm system automatically
You can set MagicSafe so that the alarm system is reactivated automatically (software
function 7 “Self-activation”, factory setting: deactivated) if the vehicle is not used
within 30 sec. of deactivating the alarm system (opening a door or switching on the
ignition). The indicator flashes twice to indicate this.
The central locking remains unaffected. If you wish the doors to be locked by central
locking self-activation, activate software function 10 “Locking the central locking
during self-activation” (factory setting: deactivated).
11.3 Deactivating MagicSafe
To deactivate the alarm system manually, proceed as follows:
➤ Press the “Unlock” button on the hand-held transmitter for approx. 1 sec.
✓ The hazard lights flash once.
✓ If the alarm system is connected to the central locking, all doors and covers are
unlocked.
Deactivating MagicSafe without the hand-held transmitter
If you have misplaced the hand-held transmitter, the batteries are empty, or the
hand-held transmitter is damaged, you can deactivate the alarm system with the
electronic key.
➤ Open the door using the vehicle key.
✓ The alarm system triggers an alarm.
➤ Insert the electronic key in the socket.
✓ The alarm system is deactivated.
If the electronic key has also been lost, the alarm system can be deactivated using the
PIN code. To enter the 5-digit PIN code, proceed as follows:
➤ Open the driver's door using the ignition key, triggering an alarm by doing so.
➤ Wait 30 sec. until the alarm stops.
✓ The status LED lights up continuously.
➤ Switch the ignition on for 1 sec. and off again within 5 sec.
✓ The status LED starts flashing.
MS660-IO-DE-DA.book Seite 44 Mittwoch, 24. August 2016 2:28 14