User manual

EN
MS660 Using MagicSafe
45
➤ Count the number of flashes until the number agrees with the first number of your
PIN code.
1 flash = number 1, 2 flashes = number 2, ..., 9 flashes = number 9, 10 flashes =
number 0.
➤ After the corresponding flashing signal, switch the ignition on for 1 sec. and off
again when the LED has gone out. This confirms the number.
✓ The status LED starts flashing again.
➤ Confirm all numbers in the PIN code in the same way.
Example: The system PIN code is “0 1 2 3 4”.
– Status LED flashes 10 x (= number 0), then switch the ignition on and off.
– Status LED flashes 1 x (= number 1), then switch the ignition on and off.
– Status LED flashes 2 x (= number 2), then switch the ignition on and off.
– Status LED flashes 3 x (= number 3), then switch the ignition on and off.
– Status LED flashes 4 x (= number 4), then switch the ignition on and off.
The PIN code has been entered.
✓ If you have entered the PIN code correctly, the alarm system will be in workshop
mode, see chapter “Setting workshop mode” on page 51.
If you have entered the PIN code incorrectly, the alarm will start again. In this
case, repeat the procedure from the start.
I
NOTE
Please note that every time a new hand-held transmitter or wireless radio
sensors (magnetic contact switch or motion detector) are programmed,
the PIN code is changed! It is therefore vital that the new PIN code is
noted in the manual for every learning process.
MS660-IO-DE-DA.book Seite 45 Mittwoch, 24. August 2016 2:28 14