User manual

EN
Using MagicSafe MS660
48
Learning the radio magnetic sensor (accessory)
➤ Disconnect the magnetic sensor contact (e. g. by opening a door secured by the
radio magnetic sensor).
✓ The read status LED on the magnetic sensor flashes once.
✓ The magnetic sensor has been learned.
Reading the PIN code
Once all hand-held transmitters and radio sensors (accessory) have been learned,
the status LED starts to flash after 10 sec. This sequence shows the new, updated
PIN code.
➤ Take a reading of the current PIN code.
Example:
Status LED flashes 10 x, then 2 sec. pause = number 0
Status LED flashes 1 x, then 2 sec. pause = number 1
Status LED flashes 2 x, then 2 sec. pause = number 2
Status LED flashes 3 x, then 2 sec. pause = number 3
Status LED flashes 4 x = number 4
The system PIN code is 0 1 2 3 4.
I
Exiting learning mode
➤ Switch on the ignition.
➤ Switch the ignition off.
➤ If you connected the yellow cable belonging to MS660 to an earth point for the
programming process, you now need to remove this connection.
➤ Insulate and store the yellow cable.
Testing the hand-held transmitter
➤ Test the new hand-held transmitter.
If a hand-held receiver does not function, then they must all be learned again.
NOTE
• Make a note of the PIN code and keep it in a safe place (e. g. at the
end of this manual, see page 56)!
• The PIN code is changed every time the hand-held transmitters are
learned.
MS660-IO-DE-DA.book Seite 48 Mittwoch, 24. August 2016 2:28 14