User manual

EN
Using MagicSafe MS660
52
11.11 Replacing the batteries
Please observe the following instructions for batteries:
!
• Only use leak-proof batteries that are suitable for electronic devices.
• Never attempt to do the following with batteries:
– recharge them,
–open them or
– throw them in fires.
• Dispose of old batteries appropriately.
Changing the battery in the hand-held transmitter
If the hand-held transmitter's range is reduced noticeably or if the control LED flickers
during transmission, the battery needs to be replaced.
➤ Undo the screw on the bottom of the hand-held transmitter.
➤ Open the hand-held transmitter.
A
➤ Change the battery (battery type CR 2032, 3 volts).
➤ Refit the lid on the hand-held transmitter and re-insert the screw.
Changing the battery in the radio motion detector (accessory)
➤ Press the housing of the motion detector in slightly on both sides and remove it.
➤ Change the battery (9 volt battery).
➤ Put the housing back onto the rear wall and click it into place.
WARNING!
Keep the batteries out of reach of children.
NOTICE!
Ensure the polarity of the batteries is correct when inserting. The positive
pole is at the top.
MS660-IO-DE-DA.book Seite 52 Mittwoch, 24. August 2016 2:28 14