User manual

EN
Installing the seat heater MSH60, MSH601
14
Installing the heating element for the seat surface
A
➤ Insert the heating element for the seat surface between the cover fabric and the
foam core of the seat (fig. 0 , page 5).
I
➤ Depending on the seat, guide this area through the stitching recess (fig. a,
page 5) or place this area through the recesses in the tunnel for the cross braces.
➤ Fasten the heating element using double-sided adhesive tape to prevent it
sliding on the foam core.
Ensure that no creases or kinks form.
Installing the heating element for the backrest
➤ Open the lower area of the backrest cover (fig. b, page 5).
➤ Push the heating element into the gap between the seat cover and the seat
cushion (fig. c, page 5).
➤ Fasten the heating element using double-sided adhesive tape to prevent
creases.
I
Installing the seat
➤ Lift the seat into the vehicle.
➤ Secure the vehicle seat with the fastening screws.
NOTICE!
The heating cables must not be damaged or bent sharply. In case you
need to make cuts in the heating element, pay attention to the routing of
the heating cables.
NOTE
To bridge the stitching recesses or the cross braces with which the seat
cover is additionally secured to the foam core, a recess is provided on
the heating element of the seat surface.
NOTE
The heating surface only needs to extend approx. 30 – 35 cm above the
seat, as the driver, when sitting normally, leans against this area only.
If the seats are equipped with side airbags, then there is a predeter-
mined breaking point in the cover fabric. The seat cover must therefore
not be pulled tightly or slip out of place.
MSH60-MSH601-IO-16s.book Seite 14 Dienstag, 30. August 2016 6:23 18