Product Manual

EN
CFF45 Troubleshooting
23
9 Troubleshooting
Fault Possible cause Suggested remedy
Device does not
function, LED does
not glow.
No voltage was
detected in the DC
power outlet.
In most vehicles the ignition must be
turned on before power will be supplied
to the DC power outlet.
No voltage present in
the AC power outlet.
Try using another plug outlet.
One of the device fuses
is defective.
Replace the defective device fuse, see
chapter “Replacing the AC fuse” on
page 20 or chapter “Replacing the
device DC Fuse” on page 20.
The integrated mains
adapter is defective.
This can only be repaired by an
authorised repair centre.
The device does not
cool (plug is inserted,
“POWER” LED is lit).
Defective compressor. This can only be repaired by an
authorised repair centre.
The device does not
cool (plug is inserted,
“POWER” LED flashes
orange, display is
switched off).
Battery monitor is set
too high.
Select a lower battery monitor setting.
Battery voltage is too
low.
Test the battery and charge it as needed.
When operating from
the DC outlet:
The ignition is on
and the device is not
working and the LED
is not lit.
The DC outlet is dirty.
This results in a poor
electrical contact.
If the plug of your cooler becomes very
warm in the DC outlet, either the DC
outlet must be cleaned or the plug has
not been assembled correctly.
The fuse of the DC plug
has blown.
Replace the fuse in the DC plug, see
chapter “Replacing the DC plug fuse” on
page 21.
The device DC fuse has
blown.
Replace the defective fuse, see chapter
“Replacing the device DC Fuse” on
page 20.
The vehicle fuse has
blown.
Replace the vehicle’s DC outlet fuse.
Please refer to your vehicle’s operating
manual.
CFF-45--O-EN-AUS.book Seite 23 Montag, 25. Juni 2018 12:42 12