Product Manual

EN
Troubleshooting CFF45
24
9.1 The lid has been forced past the built-in stop
➤ Support the lid with one hand (A).
➤ Hold the latch down with the other hand (B).
!
A
➤ Close the lid as far as possible without pinching your thumb, while still holding
the latch down, to keep it from breaking.
✓ The lid should now be approximately at angle (fig. b, page 24).
➤ Remove the hand from the latch (B), and continue closing the lid all the way.
The display shows an
error message (e.g.
“Err1”) and the
appliance does not
cool.
The appliance has
switched off due to an
internal fault.
This can only be repaired by an
authorised repair centre.
CAUTION! Health hazard!
Beware pinching your thumb while closing the lid.
NOTICE! Danger of damage!
Failure to observe this instruction can cause the lid to break off.
Fault Possible cause Suggested remedy
A
B
b
CFF-45--O-EN-AUS.book Seite 24 Montag, 25. Juni 2018 12:42 12