Instruction Manual

EN
Operation CFX95DZW
18
✓ The LED “P” lights up (fig. 3 2, page 10).
✓ The displays (fig. 3 6 and 7, page 10) switch on and show the current
temperatures.
✓ Depending on the compartment set temperatures, the cooler starts cooling
either one or both compartments.
✓ The LEDs (fig. 3 5 and 8, page 10) light up when the respective compartment is
cooling.
I
Latching the cooler lid
➤ Close the lids.
➤ Press the latches (fig. 2 1, page 10) down, until they latch in place audibly.
I
7.6 Setting the temperature
➤ Press the “SET” button (fig. 3 4, page 10):
– once for the large compartment
– twice for the small compartment
✓ The display of the respective compartment blinks.
➤ Use the “UP +” (fig. 3 10, page 10) and “DOWN –” (fig. 3 9, page 10)
buttons to select the cooling temperature.
You can adjust the cooling temperature so that each compartment works as a
refrigerator compartment or as a freezer compartment.
✓ The cooling temperature appears in the display for a few seconds. The display
flashes several times and then the current temperature is displayed again.
I
NOTE
When operating with the battery, the display switches off automatically
if the battery voltage is low. The LED “P” flashes orange.
NOTE – Lid Open Alarm
If a lid is left open for three minutes or more and the device is switched
on, the respective interior light will flash until the lid is closed.
NOTE
The temperature of each compartment can be set to –22 °C.
The manufacturer however recommends a cooling temperature of
–15 °C to –18 °C for normal usage and optimum energy consumption.
CFX-95DZW--O-AU.book Seite 18 Mittwoch, 2. November 2016 12:27 12