Instruction Manual

EN
CFX95DZW Operation
21
7.9 Set brightness of displays
The display brightness can be dimmed for low ambient light conditions. To set the
dimming level of the displays proceed as follows:
➤ Switch on the cooler.
➤ Press the “SET” button (fig. 3 4, page 4) five times.
➤ Use the “UP +” (fig. 3 7, page 4) or “DOWN –” (fig. 3 6, page 4) buttons to
set the brightness of the displays.
✓ Display will be as follows:
d0 (default), d1 (medium), d2 (dark)
✓ The displays show the set mode for some seconds. The displays flash several
times before they return to the current brightness.
I
7.10 Using the emergency switch
The emergency switch (fig. 4 1, page 12) is located below the control panel. For
normal operation the switch is in the “NORMAL USE” position.
➤ If an electronic control failure occurs, slide the switch to “EMERGENCY
OVERRIDE” position.
I
7.11 USB port for power supply
The USB port allows you to charge small devices like mobile phones and
mp3-players.
To use your cooling box with any USB devices, simply connect a USB cable (not
included) to your device.
NOTE
• The factory setting of brightness of the display is d0 (default).
• If a fault occurs, the brightness automatically is d0 (default). After
troubleshooting the set brightness is reactivated.
NOTE
If the switch is in the “EMERGENCY OVERRIDE” position, the cooler
circuit runs with full cooling capacity and, depending on the running
conditions of each compartment at the time of switching, may either
freeze one or both compartments, and/or stop cooling one of the
compartments.
CFX-95DZW--O-AU.book Seite 21 Mittwoch, 2. November 2016 12:27 12