User Manual

Page 10
5. Testing the Inverter:
•
Enerdrive Inverter is ON. AC output is now available.
•
Plug in a small AC load like a 25W table lamp or small appliance to the AC socket to verify AC is
available.
•
The unit is successfully installed and functioning properly.
6. Unit Operation
WARNING: RISK OF EQUIPMENT DAMAGE
• Do not connect an AC power source like utility power or generator to the unit AC outlets.
Turn ON and OFF the unit:
•
will turn ON to indicate the unit is powered up.
•
AC Output is available at the AC output socket and 5V USB port.
•
the unit is powered down on the AC output.
Understanding the ‘Power Save’ function
The unit can be pre-set with the ‘Power Save’ function ON or OFF. If the unit is turned ON with ‘Power
Save’ function pre-set to ON, with any AC load greater than>10W connected to the unit, the unit will
provide continuous AC Output.
With any AC load less than <10W connected to the unit or with AC Load changing from >10W to <
5W, the AC Output will change from continuous to pulsing the AC Output every 5 seconds.
The unit is default set to ‘Power Save’ OFF. To change the ‘Power Save’ function from OFF to ON or
Turn unit on by using the On/Off button on the unit. The ‘Power’ light turns on indicating the
Press the Green On/Off button OFF the inverter. The status indicator will turn OFF to indicate
Press and hold the Green On/Off button for 1-2 seconds to turn ON the inverter. The status indicator
switch back from ON to OFF, press and hold the green ‘On/Off’ button for more than 5 seconds until
the ‘Status’ light quickly flashes three times and the alarm beeps for more than 2 seconds.
Enerdrive Inverter 600W 12V Owners Manual Rev: 1.7