Manual

EN
Operation 972, 976
10
7.2 Flushing the portable toilet
I
➤ Pull out the flush grip to allow the waste to pass into the holding tank (fig. 8,
page 4).
➤ Press the flush button to flush the portable toilet (fig. 9, page 4).
➤ Push the flush grip to close the slide valve.
7.3 Emptying the holding tank
When the filling level display shows “Full”, (fig. 0, page 4), the holding tank needs
to be emptied.
➤ Pull the locking grip on the holding tank if the toilet is fitted with the optional
fastening holders. To reach the rear bracket, lift up the toilet and move it.
➤ Pull up the rear latch to disconnect the flush water tank from the holding tank
(fig. a, page 4).
➤ Take the holding tank to a reliable disposal station (or a normal toilet).
I
➤ Turn the waste pipe away from the tank and open the pressure relief valve on top
of the tank.
➤ Empty the tank (fig. b, page 4).
➤ If there is a water connection, flush out the holding tank.
7.4 Storing the portable toilet
➤ Empty the holding tank and flush water tank completely if you are not planning to
use the portable toilet for a long time.
➤ Store the portable toilet in a dry, clean state.
NOTE
Changes in the ambient temperature or the actual height above sea level
while travelling can cause the pressure in the holding tank to rise or fall.
Before use, make sure that the pressure in the holding tank is equalised
by opening and closing the slide valve with the seat cover closed.
NOTE
To protect the environment, never empty the holding tank directly into
the environment, only into an approved disposal station or a toilet.
970-Toilets-O-16s.book Seite 10 Dienstag, 23. August 2016 3:58 15