Operating instructions

20
SYSTEM RESET PROCEDURE
When your unit was installed the appropriate dip switches on the electronic control
board were turned ON to match your system confi guration. Any time these settings
are changed, a system reset will need to be done before the CCC 2 thermostat will
recognize the updated selection.
To do a system reset:
1. Make sure the CCC 2 thermostat is in the OFF mode.
2. Simultaneously press the MODE and ZONE buttons. The LCD will display “IniT”
and all available zones.
3. Release the MODE and ZONE buttons.
4. Press the ON/OFF button to exit system set up.
GENERAL INFORMATION
A. Reduce Heat Gain
The ability of the air conditioner to maintain the desired inside temperature depends
on the heat gain of the RV. Some preventative measures taken by the occupants of
the RV can reduce the heat gain and improve the performance of the air conditioner.
During extremely high outdoor temperatures, the heat gain of the vehicle may be
reduced by:
● Parking the RV in a shaded area.
● Using window shades (blinds and/or curtains).
● Keeping windows and doors shut or minimizing usage.
● Avoiding the use of heat producing appliances.
Operation on High Fan/Cooling mode will give optimum or maximum effi ciency in
high humidity or high outside temperatures.
Starting the air conditioner early in the morning and giving it a “head start” on the
expected high outdoor ambient will greatly improve its ability to maintain the desired
indoor temperature.
For a more permanent solution to high heat gain, accessories like Dometic outdoor
patio and window awnings will reduce heat gain by removing the direct sun. They
also add a nice area to enjoy company during the cool of the evening.
B. Disclaimer
The manufacturer of this air conditioner will not be responsible for damage caused
by condensed moisture on ceilings or other surfaces. Air contains moisture and this
moisture tends to condense on cold surfaces. When air enters the RV, condensed
moisture may appear on the ceiling, windows, metal parts, etc. During normal op-
eration, this unit removes moisture from the air. Keeping doors and windows closed
when this air conditioner is in operation will minimize condensed moisture on cold
surfaces.
5
C. Quick Reference To Control Buttons
Press to display
inside temperature
Press to select
temperature format
Press to decrease
temperature or humidity
set-point
Press to increase temperature
or humidity set-point
Press to display relative
humidity set-point
(Select Models)
Press to select zone
Press to select
On and OFF
Press to select
fan speed
Press to set
clock
Press to
select mode
Press to select
program 1 or 2
D. Quick Reference To LCD Icons
Temperature,
Humidity Set-Point
or Error Code
Operation Mode
Time of Day
Fan Speed
Zone
Humidity Set-Point
Percent
Dehumidify
Icon
Program
Clean or Replace
Filter
Compressor
Delay
ABOUT YOUR NEW THERMOSTAT