Operating instructions

E. Examples Of Times Programmed

F. CANbus Interface

The CANbus interface is designed to communicate between the Dometic CCC 2

thermostat and a CAN (Controller Area Network) protocol generator. Refer to the

CANbus installation instructions for more information on installation and operation

of the CANbus.

SPECIAL FEATURES

G. Fan Speed

Press the FAN button to select the desired fan speed. Each successive press will

advance to the next available speed. Your selections will be “Auto,” “LOW,” “MED,”

and “HIGH.” The fan will run continuously during “LOW,” “MED,” and “HIGH” fan

settings. The fan will cycle ON and OFF with the thermostat on “AUTO” setting. For

more information on auto fan, see section, “A. Auto Fan” on page (13).

H. Temperature Set-Point

Press the





button to change the temperature set-point. The temperature

set-point is indicated by (2) digits on the LCD. Press the



button to increase and

the



button to decrease the temperature set-point. The maximum set-point for the

system is 90 °F (32 °C). The minimum set-point is determined by the active operat-

ing mode. For heating, the minimum is 40 °F (4 °C) and minimum for cooling is 55

°F (13 °C).

PROGRAMMING & OPERATIONS