Use and Care Manual

7 Operation
7.1 Add water to bowl
To add water to the toilet,
press the ush pedal part
way down. Water ows into
the bowl while ush ball
remains closed. If the ush
ball moves, let up on the
pedal slightly. Adding water
to an empty bowl helps pre-
vent holding tank odors from
entering the living space.
Adding water is recommended prior to ushing solids and toilet paper.
7.2 Flush toilet
To ush, press pedal down until it contacts the oor. Release pedal after
complete ush.
• When ushing liquids, press the pedal for 1-2 seconds.
• When ushing solids, press pedal until contents are rinsed from bowl.
Flushing longer than necessary will cause holding tank to ll too quickly.
A small amount of water will collect in the bowl after a ush to create an airtight
seal.
Note
Residual water trickle in ceramic bowls: Due to integrated rim of
models 310, 311, 320 and 321 toilets, water may continue to trickle
into toilet bowl for up to 20 minutes after ushing. If water trickle
continues after 30 minutes, replace water valve.
Note
To ensure holding tank odors do not enter the living space, make
sure 1 inch (24 mm) of water remains in the toilet bowl. Depending
on variations in plumbing systems and user operation, the “add
water” function may be required to achieve the 1-inch water depth.
Flush directions are located under
toilet seat lid.