Operating instructions

ManualsBrandsDometic ManualsHeat Pump57915.322

INSTALLATION AND OPERATING INSTRUCTIONS

USA

SERVICE OFFICE

Dometic Corp.

509 So. Poplar St.

LaGrange, IN 46761

(260) 463-4858

CANADA

Dometic Dist.

866 Langs Dr.

Cambridge, Ontario

CANADA N3H 2N7

(519) 653-4390

For Service Center

Assistance Call:

800-544-4881

INSTALLATION & OPERATING

INSTRUCTIONS

MODELS

PRE-WIRED FOR OPTIONAL HEAT PACKAGE

57908.521

57912.621

57912.622

57912.631

57915.322

57915.331

57915.421

579 Series BRISK AIR

590 Series QUICK COOL

595 Series QUICK COOL

Roof Top Air Conditioner

USED WITH

Part No. 3107206

Air Distribution Box Kit

Mechanical

This manual must be read and un-

derstood before installation, ad-

justment, service, or maintenance

is performed. This unit must be in-

stalled by a qualified service tech-

nician. Modification of this product

can be extremely hazardous and

could result in personal injury or

property damage.

Lire et comprendre ce manuel avant

de procéder à l'installation, à des

réglages, de l'entretien ou des

réparations. L'installation de cet

appareil doit être effectuée par un

réparateur qualifié. Toute modification

de cet appareil peut être extrêmement

dangereuse et entraîner des

blessures ou dommages matériels.

REVISION:

Form No. 3107195.095 11/03

(Replaces 3107195.087)

(French 3108172.052)

LaGrange, IN 46761

57915.422

57915.521

57915.522

57915.531

57915.536

57915.541

57915.546

57915.621

57915.622

57915.631

59016.521

59016.621

59516.303

59516.331

59516.501

59516.531

59516.536

59516.601

59516.603

59516.631

Important: These instructions must stay with

unit. Owner read carefully.

RECORD THIS UNIT INFORMATION FOR

FUTURE REFERENCE:

Model Number

Serial Number

Date Purchased

Summary of content (10 pages)

PAGE 1
INSTALLATION AND OPERATING INSTRUCTIONS RECORD THIS UNIT INFORMATION FOR FUTURE REFERENCE: Model Number Serial Number Date Purchased 579 Series BRISK AIR 590 Series QUICK COOL 595 Series QUICK COOL Roof Top Air Conditioner USED WITH Part No. 3107206 USA SERVICE OFFICE Dometic Corp. 509 So. Poplar St. LaGrange, IN 46761 (260) 463-4858 Air Distribution Box Kit Mechanical PRE-WIRED FOR OPTIONAL HEAT PACKAGE CANADA Dometic Dist. 866 Langs Dr.
PAGE 2
INSTALLATION AND OPERATING INSTRUCTIONS SAFETY INSTRUCTIONS GENERAL INFORMATION A. This air conditioner is designed for: 1. Installation on a recreational vehicle during or after the time the vehicle is manufactured. 2. Mounting on the roof of a recreational vehicle. 3. Roof construction with rafters/joists on minimum of 16 inch centers. 4. Minimum of 1.00 inches and maximum of 4 inches distance between roof to ceiling of recreational vehicle.
PAGE 3
15,000 15,000 59516.603 59516.606 *** 6.9 6.6 115VAC, 60 HZ., 1PH. 12.9 12.3 11.5 11.5 11.5 12.9 12.9 11.5 12.7 12.9 12.7 11.0 11.3 11.0 11.0 11.0 11.3 11.3 12.1 12.1 12.1 11.5 11.5 11.5 12.1 12.1 8.5 8.5 11.4 11.4 12.1 9.5 8.0 8.5 COMPRESSOR RATED LOAD AMPS ELECTRICAL RATING 71.0 77.0 50.0 50.0 50.0 77.0 77.0 50.0 60.0 71.0 60.0 54.4 56.0 54.4 54.4 54.4 62.0 62.0 59.0 59.0 59.0 50.0 50.0 50.0 59.0 59.0 48.3 48.3 58.0 58.0 59.0 53.0 53.0 48.3 36.0 34.
PAGE 4
INSTALLATION AND OPERATING INSTRUCTIONS INSTALLATION INSTRUCTIONS 1. PRECAUTIONS FIG. 1 ! WARNING 1/2 L L Improper installation may damage equipment, could endanger life, cause serious injury and/or property damage. A. B. C. D. E. Read installation and operating instructions carefully before attempting to start your air conditioner installation. The Dometic Corporation will not be liable for any damages or injury incurred due to failure in following these instructions.
PAGE 5
INSTALLATION AND OPERATING INSTRUCTIONS FIG. 3 FIG. 4 7-5/8" 12.7" * Rear of Unit 14-7/8" 5-1/4" 29.5" 34.4" *10.7" FOR MODEL 57908 7-5/8" 20" 18" 14-1/4" x 14-1/4" ±1/8 Opening 22.5" 3" 2.5" Front of Unit 2-3/4" 3. ROOF PREPARATION A. B. 11-1/4" ROOF VENT REMOVAL: 1. Unscrew and remove the roof vent. 2. Remove all caulking compound around opening. 3. Seal all screw holes and seams where the roof gasket will be located. Use a good grade of all weather sealer.
PAGE 6
INSTALLATION AND OPERATING INSTRUCTIONS 3/4" Min. FIG. 7 Frame Opening Provide Hole For Wiring Recycle All Cardboard FIG. 5 5. This completes the outside work. Minor adjustments can be done from the inside if required. The 14-1/4" x 14-1/4"±1/8 roof opening is part of the return air duct and must be finished in accordance with NFPA standard 501C, Standard for Recreational Vehicles, Section 2-7. 5. A. Remove air box and mounting hardware from carton.
PAGE 7
INSTALLATION AND OPERATING INSTRUCTIONS D. E. F. C. Measure (See FIG. 9) the ceiling to roof thickness: 1. If distance is 1"-2", remove perforated tabs from both upper and lower ducts. 2. If distance is 2"-3", remove perforated tabs from bottom duct only. 3. If distance is 3"-4", install ducts as received. 4. If distance is 4"- 6", use optional duct adaptor, Part No. 3106775.004 and Bolt Kit, Part No. 3100895.006. Install ceiling template by sliding lower duct over upper duct.
PAGE 8
INSTALLATION AND OPERATING INSTRUCTIONS B. C. D. E. F. Hold air box up to ceiling template and install three (3) #10 x 3/8" screws at air box mounting point. See FIG. 12. Snap hole plug (E) into place at rear of air box. Install four (4) wood screws (B) that hold air box tight to ceiling if so desired. Reinstall return air grille and filter into air box. The air conditioner installation is now complete. Turn on power to the unit for operational check.
PAGE 9
INSTALLATION AND OPERATING INSTRUCTIONS Note: The blower runs continuously to circulate air and maintain an even temperature. The compressor will come on as cooling is required to maintain the selected temperature level. 3. HEATING OPERATION: (With Optional Heat Kit Installed) Note: This electric heater will not replace a furnace for heating your RV in cold weather. The intent is to remove the chill on cool days or mornings. A. Turn the selector switch to "OPT. HEAT". B.
PAGE 10
INSTALLATION AND OPERATING INSTRUCTIONS MOUNTING PARTS AIR CONDITIONING UNIT Discharge Air Opening A. (4) 1/4" — #20 x 7" bolts Mounting Bolt B. (4) #8 x 5/8" long sharp point wood screws Return Air Opening Threaded Hole In Bottom C. (7) #10 x 3/8" blunt point tapping screws Mounting Bolt Upper Discharge Duct Power Supply Line D. (1) Romex connector Framing Stock E.