Operating instructions

ZONE 1 configuration should have all Dip switches to

OFF position. (Refer to Figure "ZONE 1")

ZONE 2 configuration should have Dip switch 5 (ZONE

2) to ON position and all other Dip switches to OFF

position. (Refer to Figure "ZONE 2")

NOTE: If a remote sensor(s) is used, it must be

connected into the P4 (white) connector.

Improper connections can cause

component damage.

5. TWO BASEMENT AIR CONDITIONERS PLUS ONE

GAS FURNACE

To configure two basement air conditioners plus one

gas furnace, ZONES need to be established. For

explanation purposes, the front unit will be ZONE 1,

and the rear unit will be ZONE 2. Zones can be

arranged per the customer's wishes.

EACH unit must have 115V AC Only one unit requires

12VDC. Telephone communications line must be be-

tween the Comfort Control Center and ONE unit.

Another telephone communications line must be be-

tween the two units.

Two (2) furnace thermostat wires must be routed to

ONE unit.

For explanation purposes the 12VDC, Comfort Con-

trol Center telephone communications line and the two

(2) furnace thermostat wires are to ZONE 1 (front) unit.

(Refer to Diagram on top of Next Page)

ZONE 1

ZONE 2