Operating instructions

ManualsBrandsDometic ManualsHeat Pump630025

The operating instructions can change from one model to

another.

Be sure you are familiar with the proper operating instructions

for the specific model of air conditioner you are diagnosing. An

installation and operating manual is packaged with each air

conditioner system.

1D.1D.

1D.

MECHANICAL CONTROLSMECHANICAL CONTROLS

MECHANICAL CONTROLS

This type of air conditioner has an air distribution box that has

a mechanical selector switch and thermostat installed in it.

CONTROLSCONTROLS

CONTROLS:

The Selector Switch has eight positions including "OFF". This

controls fan speed, heating mode and cooling modes.

The Thermostat controls the temperature range from 65°F on

the coldest side to 90°F on the warmest side. In the cooling

mode, the compressor ON/OFF is controlled by the thermostat

setting.

COOLING OPERATIONCOOLING OPERATION

COOLING OPERATION:

Set the thermostat at the desired temperature level.

Select the fan speed that best satisfies your needs.

HIGH COOLHIGH COOL

HIGH COOL: Selected when maximum cooling and

dehumidification is required.

MED. COOLMED. COOL

MED. COOL: Selected when normal or average

cooling is required.

LOW COOLLOW COOL

LOW COOL: Selected when room is at desired

comfort level and needs to be maintained. Normally

this speed is used for nighttime operation.

NOTENOTE

NOTE: The blower runs continuously to circulate air and

maintain an even temperature. The compressor will come on

as cooling is required to maintain the selected temperature

level.

AFTER SHUTTING THE AIR CONDITIONER DOWN WITHAFTER SHUTTING THE AIR CONDITIONER DOWN WITH

AFTER SHUTTING THE AIR CONDITIONER DOWN WITH

EITHER SELECTOR SWITCH OR THERMOSTAT, WAIT ATEITHER SELECTOR SWITCH OR THERMOSTAT, WAIT AT

EITHER SELECTOR SWITCH OR THERMOSTAT, WAIT AT

LEAST TWO (2) MINUTES BEFORE RESTARTING. THISLEAST TWO (2) MINUTES BEFORE RESTARTING. THIS

LEAST TWO (2) MINUTES BEFORE RESTARTING. THIS

ALLOWS THE REFRIGERANT PRESSURE TO EQUALIZEALLOWS THE REFRIGERANT PRESSURE TO EQUALIZE

ALLOWS THE REFRIGERANT PRESSURE TO EQUALIZE

AND COMPRESSOR TO RESTART EASILY.AND COMPRESSOR TO RESTART EASILY.

AND COMPRESSOR TO RESTART EASILY.

FAN OPERATIONFAN OPERATION

FAN OPERATION:

This will circulate the air in your RV without cooling or heating.

There are three positions: HIGH FAN, MED. FAN or LOW FAN

to select from, depending upon personal choice.

HEATING OPERATION:HEATING OPERATION:

HEATING OPERATION:

(With Optional Heat Kit Installed)(With Optional Heat Kit Installed)

(With Optional Heat Kit Installed)

NOTE: This electric heater will not replace a furnace for heating

your RV in cold weather. The intent is to remove the chill on cool

days or mornings.

1. Turn the selector switch to "OPT. HEAT".

2. The heater will come on and begin heating.

3. When desired temperature level in RV is reached, move the

selector switch to off position or fan position. (NOTE:

Thermostat does not control heater ON/OFF cycle.)

"OFF" POSITION"OFF" POSITION

"OFF" POSITION: This is to turn Unit off.

2D.2D.

2D.

ELECTRONIC CONTROLSELECTRONIC CONTROLS

ELECTRONIC CONTROLS

This type of air conditioner has a main board and a control

board that replaces the mechanical switch and thermostat on

the mechanical controlled air conditioner. The control board

can be mounted in the air distribution box or on a wall. The

control board that is mounted on a wall allows the air condi-

tioner to utilize a ceiling duct to distribute the cool air throughout

the structure. NOTE: Remember to check the installation and

operating instructions for the specific model of air conditioner

you are diagnosing.

PRE-WIRED F OR OPT. HEAT

HIGH

MED

LOW

OFF

FAN

COOL

LOW

MED

HIGH

COLDER

by Dometic

SECTION D. OPERATING INSTRUCTIONS